Battery Charging - VR46 MOTOR BIKE-X Manuel D'utilisation

CAUTION
Prior to using the item for the first time, charge to 100%. Ensure the item, charger, and charging port are dry. The activity must only be performed
by an adult.
Instructions:
- Switch off the item
Model Reference picture
Motorbike-X
To recharge the item, use ONLY the battery charger supplied
CAUTION
Model
Motorbike-X
Using another type of charger may damage the scooter or entail other potential risks. Never leave the item unsupervised while it is charging. Do
not switch the product on while it is charging.
After each use, fully recharge the battery to extend its useful life. Do not recharge the item immediately after use. Allow the scooter to cool for an
hour before recharging.
The item should not be charging for extended periods. Overcharging reduces battery life and poses additional potential hazards.
Allow the vehicle to discharge completely to prevent damage to the battery.

4. Battery charging

Charging port
A
Charging status
indicator
Charging connector
B
Battery charger model
CP2515
Instructions
1. Before recharging the vehicle, make sure it is turned
off.
2. Open the rubber plug located on the charging port
(inside side of the frame).
3. First insert the plug (A) of the charger into the
mains socket, then connect the connector (B) to the
vehicle's charging port.
4. When the battery is charged (green light), pull out
the charger connector, remember to reinsert the
rubber plug into the charging port.
CAUTION
The red light on the charger will turn green when
charging is complete
Output voltage
25.2V, 1.5A
10
Charging time
3-4 hours