Publicité
Step 15
NOTE: Position the BACKS (V) exactly as shown.
å
Fasten the BACKS (V and Z) to the ENDS (A3 and B3),
å
HEADBOARD TOP (E3), SLATS (I3), and HEADBOARD (S). Use
twenty-eight BLACK 9/16" LARGE HEAD SCREWS (1S).
NOTE: The outside edges of the BACKS (V) will be fastened last.
å
NOTE: There are no pre-drilled holes in the edges of the ENDS (A3
å
and B3). Use fi rm pressure when fastening the outside edges of the
BACKS (V) to the ENDS (A3 and B3).
www.sauder.com/service
NOTE: Fasten the outside edges
of the BACKS (V) last using fi rm
pressure. The two smaller holes in
the edges of the BACKS (V) must
line up over the ENDS (A3 and B3).
BLACK 9/16" LARGE HEAD SCREW
(28 used in this step)
I3
e d
n i s h
U n fi
e
f a c
s u r
V
A3
A tracking label will be on this
surface of one of the BACKS (V).
Please do not remove.
414129
If you're doing this to
help a friend, don't
leave without a bite.
1S
B3
E3
e d
n i s h
U n fi
e
f a c
s u r
e d
n i s h
U n fi
e
f a c
V
s u r
Z
S
Page 19
Publicité
