Intellinet Network Solutions 560641 Manuel D'instructions page 2

PoE Desktop Gigabit Switch
CONNECTIONS & INDICATORS
LEDs
The LED indicators make it
easier to monitor the switch
and its connections.
Ports
All ports on the switch support
Auto-MDI/MDI-X functionality,
so crossover cables and uplink
ports are not needed for
connections to PCs, routers,
other switches, etc. Cat5/5e/6 UTP/STP cables provide optimal performance; if a status LED
doesn't indicate a link or activity, check the corresponding device for proper setup and
operation.
• Power consumption: 135 watts (maximum)
• Ports 1-4: PoE / PoE+ (up to 34 watts per port)
• Ports 5-8: PoE (up to 15.4 watts per port)
Power
Use the included power cord to connect the device (next to the On/Off switch on the rear
panel) to an AC outlet. Confirm that the power LED on the front panel is lit.
PLACEMENT
Prior to use, it is recommended that the switch be placed/positioned:
• on a level surface that can support the weight of the switch
• with a minimum of 25 mm (approx. 1") of clearance on the top and sides for adequate
ventilation
• away from sources of electrical noise: radios, transmitters, broadband amplifiers, etc.
• where it cannot be affected by excessive moisture
Rackmount
The switch includes brackets and screws for optional rack mounting.
1. Disconnect any cables from the switch.
2. Position a bracket over the mounting holes on one side of the switch and secure it in place
with screws.
3 Repeat Step 2 on the other side of the switch.
4. Position the switch in the rack and screw the brackets to the rack.
5. Reconnect any cables.
2
ENGLISH
LED Status
Power On
Off
PoE On
Off
Link/Act On
Blinking
Off
Loop Blinking
Off
Operation
Power on
Check the AC connection; turn the power on
Port is linked to a PSE/PoE device
No PSE/PoE device is linked
Valid port connection
Valid port connection; data transmitted/received
No link established
A loop exists
No loop
POWER
ON/OFF
English
AC INPUT 100-240VAC
50/60Hz 2A MAX