Operation; Before Initial Use - Uccello UDK USBW Mode D'emploi

Masquer les pouces Voir aussi pour UDK USBW:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OPE R AT ION

Before Initial Use

If you are using your Uccello Kettle for the first time, it is recommended that you clean your Kettle before
use by boiling a full Kettle of water twice and then discarding the water.
Kettle Operation
1.
To fill water into the Uccello Kettle, remove it from the power base and open the lid by pressing the
Open lid Button. Fill with the desired amount of water. Always fill the Uccello Kettle between the
minimum (0.7l / 24fl. oz / 3 cups) and maximum (1.5l / 50fl.oz / 6 cups) marks. Too little water
will result in the Kettle switching off before the water has boiled.
NOTE: Do not fill the water over the maximum level as water may spill out of the spout when
boiling. Ensure that the lid is firmly in place before connecting the power cord to the outlet.
2.
Position the Uccello Kettle in the Cradle.
3.
Connect the plug into a power outlet. Press the Switch Button below the handle. The Indicating light
in the On/Off switch will light up. The Kettle will switch off automatically once the water has boiled
and the light extinguishes. You can shut off the power by pressing the switch button at any point
during boiling water.
NOTE: Ensure that switch is clear of obstructions and the lid is firmly closed. The Kettle will
not turn off if the switch is constrained or if the lid is left open.
4.
While holding the handle rotate the Uccello Kettle in the Cradle to pour the water.
NOTE: Operate carefully when pouring the water from your Uccello Kettle as boiling water
may result in scalding. Do not open the lid while the water in the Kettle is hot.
5.
The Uccello Kettle will not re-boil until the switch is uplifted. Allow to cool for 15~20 seconds
before opening to boil water. The Uccello Kettle may be stored on the Cradle when not in use.
NOTE: Ensure power supply is turned off when Kettle is not in use.
Boil-Dry Protect
Should you accidentally allow the Uccello Kettle to operate without water, the Boil-Dry protection will
automatically switch it off. If this should occur, allow the Uccello Kettle to cool before filling with cold
water and re-boiling.
13

Publicité

Table des Matières
loading

Table des Matières