Ec Declaration Of Conformity - Goizper evolution 20 LTC S Manuel D'instructions

The battery does not charge up or its
autonomy has been reduced.
The motor is running but it does
not spray
The motor works but the spray does
not reach the pressure or spraying
is irregular.
The motor does not stop when the
handle is released.
The handle does not close
The motor runs intermittently when
spraying.
WARRANTY
8
Our goods have a two year warranty, from the date of purchase by the user, against any manufacturing or material defect. The
warranty is strictly limited to free replacement of parts that our services consider defective. The warranty shall not apply in case
of improper use of our materials, disassembly and/or alterations performed to our devices, and to those parts of normal wear and
tear that require maintenance The warranty shall not apply in case of negligence, imprudence and irrational use of the material.
Dispatch and transportation costs of parts under warranty as well as workmanship that were not performed in our factory shall be
borne by the user. To invoke this warranty, send us the part subject matter of the claim, carriage free, together with the receipt or
the purchasing invoice.
9

EC DECLARATION OF CONFORMITY

We,
Goizper Group - C/Antigua 4 – E-20577 Antzuola - Spain
declare under our sole liability that this product complies with Directives 2006/42/EC and 2009/127/EC in compliance with
the harmonised EN ISO 19932-1:2013; EN ISO 19932-2:2013; EN ISO 14982:2009.
Antzuola, 2021 February.
Aitziber Uriarte, Technical Director
The charger is the original charger and works correctly. Check the
battery charge section.
The battery is old. Its service life is nearing its end (battery life
<65% of nominal)
The battery is new
Clean the hydraulic circuit
The amount of fl uid in the sprayer
The recommended working positions for each nozzle
Cleaning the suction fi lter of the tank (Ref. 1251)
Hydraulic connections and leakages
Air in the hydraulic circuit
The condition of the nozzle
Check if the pump or the electronics are damaged
The amount of fl uid in the sprayer
Cleaning the suction fi lter of the tank (Ref. 1251)
Air in the hydraulic circuit
Hydraulic connections and leakages
Check if the pump is damaged
The condition of the joints
The selected nozzle has a nominal fl ow rate less than that
recommended in the nozzle table.
Cleaning the nozzle, its fi lter and handle fi lter. [3.5]
Replace the charger if it fails to work
Replace the battery
Contact the distributor
Raise the appliance to table height and place the handle in a
lower height, with the appliance switched on and the handle
activated. Hold this position for a few seconds
Fill the sprayer with the product to be sprayed
Use the nozzles and work positions recommended in the
nozzle selection tables T.1 and T.2.
Clean the fi lter if necessary
Tighten any joint if necessary
Stop the motor and restart the equipment to spray a few
seconds with the lance pointing upwards
Replace the nozzle if damage is perceived or
considerable wear and tear is discerned.
Contact the distributor
Fill the sprayer with the product to be sprayed
Clean the fi lter if necessary
Stop the motor and restart the equipment to spray a few
seconds with the lance pointing upwards
Tighten any joint if necessary
Contact the distributor
Change and grease the joints or the fi lter with joints.
Use the nozzles and work positions recommended in the
nozzle selection tables T.1 and T.2.
Clean the fi lters if necessary