Product Features; System Type - Vimar Elvox ESM2 Manuel Installateur

ESM2, ESM2.120, ESM2.D, ESM2.D.120, ESM2.W, ESM2.W.120, ESM2.1000.W, ESM2.1000.W120

1 - Product features

ACTO 600D automatic gate system for heavy-use residential and condominium sliding gates. The non-reversible, electromechanical actuator is equipped
with a low-voltage 24 Vdc motor and a mechanical release which enables the gate to be opened and closed manually. The motor operates a gear
unit, lubricated with permanent grease, which is enclosed in a thick but extremely compact die-cast aluminium housing. The electronic control board is
integrated in the body of the actuator, with the provision of a housing for the back-up battery (optional).
Technical characteristics
Supply voltage
Frequency
Board voltage supply
Motor voltage supply
Frequency of use
Rated motor power
Speed
Rack
Operating temperature
Protection rating
Noise
Maximum gate weight
Dimensions (WxHxD)
Motor weight

2 - System type

G
H
2x0.5 mm²
Components for implementing a complete system
Main Components
Description
Actuator
Blinking
Wall-mounted photocells
Key selector
Rack
Preliminary checks
For the automatic gate system to function properly, the structure of the existing gate, or the one to be made, must meet the following
requirements:
- The wheels of the gate are mounted in such a position as to provide stability to the gate and are in a good condition and efficient.
- The rail is clear, straight and clean throughout its length with mandatory stops for both opening and closing.
- The top guide is aligned with the rail, the sliding blocks are intact and lubricated and with a clearance of approximately 1 mm. on
each side so as to facilitate the sliding of the gate leaf.
- The spaces between the moving and fixed parts of the gate are of the size required by the national standards or in any case comply
with safety standards by applying an adequate protection system.
- The weight of the gate must not exceed 600 kg
- No mechanical closing locks.
It is recommended to take the necessary steps to ensure the reliability and safety of the automatic gate system
ESM2.120 120 Vac (+10%, -10%)
D
A
F
4x0.5 mm²
3x1.5 mm² (230 Vac)
Ref.
A
B
D
E
F
EN
ESM2 230 Vac (+10%, -10%)
50-60 Hz
Heavy duty service
140 W
10 m/min
Module 4
From -25°C to +55°C
< 70dBA
600 Kg
308x270x225 mm
4x0.5 mm²
Accessories (optional)
Description
Post-mounted photocells
Posts
ESM2.1000 230 Vac (+10%, -10%)
ESM2.1000 120 Vac (+10%, -10%)
22 Vac
24 Vdc
160 W
9 m/min
IP45
1000 kg
10.8 kg
B
2x1 mm²
E
3x0.5 mm²
D
2x0.5 mm²
G
H
Ref.
G
H
9