Characteristics; Application - Artidor AR-030 Manuel D'installation

•
Follow all instructions written on the equipment and as mentioned in this manual.
•
Repairs may only be carried out by the manufacturer or by a person appointed by the
manufacturer.
E
•
Modifications to the equipment or changes to the design are not permitted.
•
The product may only be used for the function for which it is designed and shall be
maintained in a good and clean condition.
If these instructions are not followed the explosion safety of the equipment cannot be
guaranteed. The equipment could then endanger the life of the user and could cause the
ignition of an explosive atmosphere. Consequently, Artidor as the manufacturer will waive
any responsibility.
3.

Characteristics

The characteristics can be summarized as follows:
•
Very solid
•
Manufactured from impact-resistant plastic, galvanized magnet
•
Provided with a factory sealed cable
•
Double isolated and therefore an earth connection is unnecessary
•
Fabricated based on European Guideline 2014/34/EU (ATEX 114)
•
Explosion-safe according category II 3GD and therefor suitable for use in zone 2 and 22
•
Protection rating Ex ic mc IIC T6 Gc, Ex ic mc IIIC T80ºC Dc
•
Ingress protection level: IP65
•
Surface mount on floor, ceiling or wall
4.

Application

The explosion-safe AR-030 door magnet has been designed for and are suitable for use in
hazardous classified areas due to flammable gases, vapors, mist, fibers and dust. Because
they are explosion-safe and certified on the basis of Group II Category 3GD of the ATEX
Directive they are suitable for use in the following types of zones in explosion hazardous
areas:
•
for combustible gases, vapors and mist: zone 2
•
for combustible fibers and dust: zone 22
Installation manual explosion-safe AR-030 door magnet
6 / 36
12-2022