Toparc Kit NUM-1 Mode D'emploi page 7

Any access to internal areas beyond the areas described in this video guide is prohibited and voids the warranty and any other form of support.
Indeed, these manipulations may be damaging to the parts and/or the internal electronic components of the generator.
HARDWARE ERROR
If the following error appears in the display, the «Slave» configura-
tion of the NEOFEED/PULSFEED wire feeder was not followed.
The configuration is visible in the video (see above).
ON ON ON
Master
1 2 1 2 1 2
SCREEN DISPLAY
Wire Feeder N°1 = Master
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported.
ON
Slave
1 2
Wire Feeder N°2 = Slave
KIT NUM-1
HARDWARE Error
NODE : MMI
CODE : 0000
...
The functionalities of the «Slave» wire feeder are
limited.
EN
7