Publicité
ENGLISH
Read the instructions carefully before
beginning the installation and carry
out the procedures as specifi ed by the
manufacturer. • Only use this product for
its intended purpose. Any other use is
hazardous. • The manufacturer cannot
be held liable for any damage caused
by improper, unreasonable or erroneous
use. • Before connecting up the electrics,
disconnect the power supply and any
batteries. • The device must be installed,
wired, connected and tested according to
good professional practice, in compliance
with the standards and laws in force. • This
product complies with current applicable
reference standards.
Dismantling and disposal
Dispose of the packaging and the device responsibly at the
end of its life cycle, in compliance with the laws in force
in the country where the product is used. The recyclable
components are marked with a symbol and the material ID
marker.
THE DATA AND INFORMATION IN THIS MANUAL MAY BE
CHANGED AT ANY TIME AND WITHOUT NOTICE.
THE MEASUREMENTS, UNLESS OTHERWISE STATED, ARE IN
MILLIMETRES.
Description
Board kit for operation during power outages and for
recharging the batteries, complete with battery housing.
Technical data
MODELS
Absorbed current (mA)
Operating temperature (°C)
Protection rating (IP)
Insulation class
Description of parts
1
Battery support bracket
2
LBB board
3
Battery base bracket
4
Connection cable for terminal board 24 - 0
5
Connection cable for terminal board 17 - 0
6
Black cable for battery
7
Red cable for battery
8
Jumper cable for batteries
9
DIN bracket
10
Screws UNI5739 6 x 16
11
Hex nut UNI7474 M6
12
Screws UNI6954 3.9 x 9.5
13
Cable tie
14
Terminal board for battery cables
15
Terminal board 17 - 0
16
Terminal board 24 - 0
17
Status warning LED
18
10A fuse
19
Spare fuse
Status warning LED
LED
Green on
Flashing green
Blue on
Red on
Red fl ashing
Flashing red and green
With battery operation, the manoeuvring speed is
reduced.
The contents of this manual may be changed at any time
803XA-0290
and without notice.
400
Translation of the original instructions.
-20 ÷ +55
20
III
Message
Power on. Batteries are
charged.
Power on. Batteries are
charging
Device is battery powered.
Batteries are fl at.
After replacing the batteries,
check their status.
Batteries disconnected or
LBB board fuse burnt
Publicité
