Protocol DURA VR Manuel D'instructions page 17

TROUBLESHOOTING
*Allow 15 minutes to pass between full flights as this will give the motors a chance
to cool down. Failure to do so could wear out and shorten the life of the motors.
SYMPTOM
Dura VR
does not
respond
Response to
control inputs
intermittent or
erratic
Dura VR
will not hover
or strafe
correctly
The motors
stop running
HOW TO CHANGE THE BLADES
- All drones have two rotors that spin clockwise and two rotors that spin
counter-clockwise.
- Make sure to place the blades on the correct axis or they will not spin
correctly and the drone will not lift.
- Each blade is marked with A or B. There may be a number after the
letter but you can ignore the number.
- Make sure to follow the graphic below to see where to place the blades.
POSSIBLE CAUSE
1. Communication between
controller and aircraft was not
synchronized during set up
2. Battery power depleted on
aircraft, controller or both.
1. Controller battery power
nearly depleted.
1. The aircraft was not
on level ground during
synchronization.
2. Trim settings are incorrect.
1. If a propeller is stuck, the
motors will automatically stop
running.
A
B
CAMERA/FRONT
POTENTIAL SOLUTION
1. To synchronize, turn on aircraft
first, place it on level ground, and
then turn on controller.
2. Charge aircraft and/or replace
batteries in controller.
1. Replace batteries in controller.
1. Re-synchronize aircraft and
controller.
2. Reset the trim buttons on the
controller and re-trim flight controls.
1. Pull the throttle down and release
to start the engines.
B
A
13