Start-Up Procedure - Protocol DURA VR Manuel D'instructions

START-UP PROCEDURE

Before flying, the drone and transmitter must be turned on in sequence
and synchronized.
1. Turn on the drone by pressing the on button and holding for 3 seconds. The
lights on both sides of the drone will flash to indicate it's on. Place it on an
even surface. The green lights on the drone are at the front and the red are at
the back.
2. Turn on the remote control.
3. Push the throttle the down and then release. The remote will beep three times
and the flashing lights on the drone and remote will turn steady to indicate it
has synced.
4. Your drone is now synchronized, and in stand-by mode awaiting Engine
Idle command.
NOTE:
1. If after 30 seconds, it has not recognized the drone, turn off the controller
and repeat Start-Up procedure.
STARTING THE ENGINE; ENGINE IDLE
After synchronizing the drone, move the throttle and direction sticks in to the lower
center corners (blue lines) and release to go into Idle mode. The blades will rotate
but the drone will not lift.
6