Behringer CM1A Guide De Démarrage Rapide page 11

Table des Matières

Publicité

20
CM1A
SYNTHTRIBE
Hämta SYNTHRIBE-programmet från behringer.
com för att justera pitch bend-intervallet, välja
MIDI-kanal och CV-läge och justera tonintervallet
(C0 till C9) och göra andra kalibreringar.
(PL) Wybór trybu
Met een knop op het achterpaneel kan de CM1A
worden geconfigureerd voor diverse synth-
families van Behringer. De eerste LED geeft aan of
het CV-bereik optimaal is voor systeemmodules
15/35/55 of de System 100/2500-serie. De tweede
LED geeft monofone of duofone werking aan.
Druk snel op de knop om het CV-bereik om te
schakelen, of houd hem vast om tussen monofoon
en duofoon om te schakelen.
SYNTHTRIBE
Pobierz aplikację SYNTHTRIBE z behringer.com,
aby dostosować przedział podciągnięcia dźwięku
(pitch bend), wybrać kanał MIDI oraz tryb CV,
dostosować przedział dźwięków (C0 do C9) oraz
inną kalibrację.
(EN) Power Connection
The unit comes with the required power cable for
connecting to a standard Eurorack power supply
system. Follow these steps to connect power to
the module. It is easier to make these connections
before the module has been mounted into a
rack case.
1. Turn the power supply or rack case power off
and disconnect the power cable.
2. Insert the 16-pin connector on the power cable
into the socket on the power supply or rack
case. The connector has a tab that will align
with the gap in the socket, so it cannot be
inserted incorrectly. If the power supply does
not have a keyed socket, be sure to orient pin 1
(-12 V) with the red stripe on the cable.
3. Insert the 10-pin connector into the socket on
the back of the module. The connector has a
tab that will align with the socket for correct
orientation.
4. After both ends of the power cable have been
securely attached, you may mount the module
in a case and turn on the power supply.
Installation
The necessary screws are included with the
module for mounting in a Eurorack case. Connect
the power cable before mounting.
Depending on the rack case, there may be a series
of fixed holes spaced 2 HP apart along the length
of the case, or a track that allows individual
threaded plates to slide along the length of the
case. The free-moving threaded plates allow
21
Quick Start Guide

Publicité

Table des Matières
loading

Table des Matières