Taurus ARTIS 60 WHITE Mode D'emploi page 13

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 15
Once you have finished using the appliance:
Stop the appliance by pressing the stop button
(Fig.3).
Safety thermal protector:
The appliance has a safety device, which
protects the appliance from overheating.
If the appliance turns itself off and does not
switch itself on again, disconnect it from the
mains supply, and wait for approximately 15
minutes before reconnecting. If the machine
does not start again seek authorised technical
assistance.
Practical tips:
It is recommended to keep the filters clean,
grease and dirt in the filters decreases the
efficiency of the engine and increases its energy
consumption.
Adjust the extraction speed according to the
amount of smoke, working at high speeds with
little smoke consumes more energy.
Cleaning
Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
Remove the filters, clean in hot, soapy water or
in a dishwasher. Replace parts correctly.
Cleaning is recommended every month.
NOTE: If you clean the filters in the dishwasher,
they may change colour slightly.
Never submerge the appliance in water or any
other liquid or place it under running water.
If the appliance is not maintained in good
cleaning condition, its surface can degrade and
inexorably affect the life of the appliance and
lead to a dangerous situation.
Then dry all parts before its assembly and
storage.
Changing the bulb/s:
LED
You must purchase the specific spare part for
your model.
Steps to follow:
1. Disconnect the hood from the mains.
2. Press the LED to push towards the inside.
3. Disconnect the connector.
4. Introduce the new LED and push to place it in
its place.
5. Reconnect the connector.
Changing the filters:
For activated carbon filters (if applicable), it is
advisable to replace them at least once a year or
every 48 hours of operation.
In the case of permanent mesh filters, they do
not need to be replaced.
Supplies
Supplies can be acquired from distributors and
authorised establishments (such as filters,
bulbs...) for your appliance model.
Always use original supplies, designed
specifically for your appliance model.
Anomalies and repair
In the event of a fault, call the customer service
telephone number indicated on the guarantee
sheet (that you will find at the end of this
manual). Do not attempt to disassemble or repair
the device yourself as there may be danger.
For EU product versions and/or in case that it
is requested in your country:
Ecology and recyclability of the product
The materials of which the packaging of this
appliance consists are included in a collection,
classification and recycling system. Should you
wish to dispose of them, use the appropriate
public recycling bins for each type of material.
The product does not contain concentrations of
substances that could be considered harmful to
the environment.
This symbol means that in case you
wish to dispose of the product once its
working life has ended; take it to an
authorised waste agent for the selective
collection of Waste from Electric and
Electronic Equipment (WEEE).
This appliance complies with Directive
2014/35/EU on Low Voltage, Directive
2014/30/EU on Electromagnetic Compatibility,
Directive 2011/65/EU on the restrictions of the
use of certain hazardous substances in electrical
and electronic equipment and Directive
2009/125/EC on the eco-design requirements for
energy-related products.
The following information is regarding to energy
labelling and eco-design:

Publicité

Table des Matières
loading

Table des Matières