brondell FreshSpa Manuel Du Propriétaire page 9

PRODUCT INSTALLATION
Installing the bidet attachment
4. Connect the bidet hose to the T-valve.
a. The ends of the bidet hose are two different
sizes. Determine which is the smaller of the
two ends.
b. Connect the smaller end of the braided metal
bidet hose to the remaining open side of the
installed T-valve.
5. Install adjustable mounting brackets into the
bidet attachment.
a. Line up the dots of one of the adjustable
mounting brackets with the dots around one
of the open mounting bracket holders.
b. Push the bracket into the bracket holder until
it snaps into place.
c. Repeat steps 1 and 2 to install the other
adjustable mounting bracket.
6. Install bidet attachment on toilet.
a. Place bidet attachment on the toilet with
the nozzle(s) close to the back of the toilet,
leaving a slight gap between the toilet and
the nozzles. This will vary by toilet.
b. Make sure the adjustable brackets line
up with the holes in the toilet fixture. You
may need to rotate the adjustable brackets
accordingly to line up properly.
c. Replace the toilet seat on top of bidet
attachment and secure using original toilet
seat hardware. Make sure to tighten so that
the bidet attachment and seat do not move.
d. Ensure that no buttons on the control
panel are depressed to prevent water from
accidentally spraying out of the toilet bowl.
Step 4b
Step 6a
Step 6b
Step 6c
7