Remote Control - Best CC34IQSB Mode D'emploi

REMOTE CONTROL

The remote control is linked to the hood at the factory.
If, for some reason, the link is lost - follow the directions below:
To Link Remote Control to Hood
1. Turn off hood motor and hood lights.
2. Press and
control Indicator Light turns on (Fig.3). Release button. The indicator light will light up. (Fig. 3)
3. Within 3 seconds - press
approximately 10 seconds to confim that the linking process was successful.
Remote Control Functions (Fig.3)
Delay - Off
Blower Speed Decrease and Off
Blower Speed Increase and On
Light
Press (Delay) and
IMPORTANT: Holding
remote and hood to be lost.
Battery disposal
When the batteries need to be replaced, dispose of them only and exclusively in the numerous readily available
special waste bins, especially in shops selling electronic consumer goods. Observance of the regulations on
differentiated waste collection, in particular, proper disposal of used batteries, contributes to preventing possible
negative effects on the environment and health.
buttons on the remote simultaneously for 5 seconds, until the remote
ƒ
(P2) on the hood control. (Fig. 4) The LED ring will light up for
INDICATOR
LIGHT
FIG. 3
See "Controls" section on previous page for
more information on each function.
(Light) together to Reset Filter Alarm.
(Delay) for more than 3 seconds will cause the link between the
- 5 -
HOOD
CONTROL
¤
(P1)
(P4)
+
-
(P5)
(P3)
ƒ (P2)
L1
LED
RING
FIG. 4