Lint Tray; Cutting Width Gauge; Thread Cutter - Texi Joylock 2/4 Manuel D'utilisation

EN

LINT TRAY

During the sewing with edge knife you
can use lint tray. Mount fastener A1 to
hole A, and bolt from left side put above
hole B (as it is shown on the picture).
With the lint tray located in this position,
it will collect all your waste material.
After completion of work if you then turn
tray upwards in direction shown, finger
Ref C will locate in slot D and left hand pin will slide into lower hole B.

CUTTING WIDTH GAUGE

When using cutting width gauge, the
fabric is cut down and sewn at same
distance from the edge of fabric. Within
the distance of the width adjusted.

THREAD CUTTER

Thread cutter is built in needle plate.
Make sure that power switch is off, then
trim thread near the end of fabric by
pushing down lever as illustrated.
64
Texi Joylock 2-4 instrukcja 2017.indd 64 Texi Joylock 2-4 instrukcja 2017.indd 64
Texi Joylock 2/4
18.09.2020 11:48 18.09.2020 11:48