Orbegozo HPE 8075 Manuel D'instructions page 18

HPE 8075
2. Take out the inner tank and fill in food and water. Food and water should be no higher than 4/5 and no
lower than 1/5 of the height of inner tank, and for expandable food, no higher than 3/5.
3. Clean the inner tank and heating plate before put in the inner tank. Be sure no dirt or smear on the
heating place and outer tank. After that, turn slightly the inner tank to make it well fit to the heating
plate.
4. Put on the cover.
 Check the sealant washer; make sure it has been put on the inner steel ring.
 Turn the sealant washer to make sure it well fit to the steel ring.
 Cover up the lid and turn it counter-clockwise until it gears with a clamping sound.
5. Put the pressure discharging in its position. Then set it to "seal" point. Be sure that the floating valve is in
down position.
6. Press the menu button (press "rice" for rice cooking, for example) and the indicator lights up.
7. For function menu, please refer to cooking instructions to set proper pressure keeping time. Press the
"optional pressure holding time" button and the timer increases by 10 min. The maximum time setting is
99 minutes and after that, it begins a new cycle (optional pressure holding time denotes the time
pressure sustained after it gets to desired working pressure).
After time setting, press "function menu" button. The timing indicator will flash and the "function menu"
indicator lights up. If you have pre-set the time, the timer will decrease each time by 10 min. When the
countdown ends, the display shows "00", the timing indicator goes out and the cooking begins.
18