Publicité
Les langues disponibles
Les langues disponibles
10. Find and Unbind a Zigbee Lighting Device
Step 1: Start find and bind mode on
the Zigbee lighting device (initiator
node) and enable it to find and bind
target, refer to its manual.
Step 2: Short press the group
button that the device already
bound to.
Step 3: Press and hold down until
LED indicator turns on.
11. Clear All Find and Bind Mode Paired Lighting Devices
Step 1: Short press to choose the
group that you would like to unbind
all devices.
Step 2: Press and hold down until
LED indicator turns on.
12. Setup a Network & Add Devices to the Network (No Coordinator or Hub Required)
Step 1: Factory reset the remote
and the lighting device, refer to
their manuals.
Step 3: Short press the group
button that the device was linked to.
Step 5: Add more remotes to the network as you would like.
Step 6: Factory reset the lighting devices that you would like to add to the network, refer to their manuals.
Step 7: Touchlink to pair the added remotes and lighting devices you would like to add, the devices will be added
to the network through Touchlink, refer to their manuals.
13. OTA
The remote supports firmware updating through OTA, and will acquire new firmware from zigbee controller or
hub every 10 minutes automatically.
LED indicator
ZigBee Lighting Device
Step 4: Short press twice to enable
the remote (target node) to find and
unbind initiator. LED indicator
flashes 4 times for successful
unbinding or twice if unbinding fails.
LED indicator
Step 3: Short press 5 times
continuously to clear all bound
lighting devices . LED indicator
flashes 4 times for successful
unbinding.
LED indicator
Step 2: TouchLink the remote and
device to setup a network, refer to
their manuals.
< 10cm
ZigBee Lighting Device
Step 4: Set another remote into
network pairing mode and pair it to
the network, refer to its manual.
14. How to Check Whether the Remote Belongs to a Network or not
Short press any other buttons except group buttons, indicator blinking means the remote has already been
added to a network, no blinking of indicator means the remote does not belong to any network.
Wiring diagram
ZigBee Controller
L
N
L
N
Installation
Publicité
