Getting Started - Hamilton Beach Professional Durathon 19573 Mode D'emploi

Getting Started

How to Fill the Tank
1. Pull water tank fill cover
outward to open.
2. Fill water tank slowly using a
spouted cup or botlle.
3. Do not fill past MAX fill line
on water tank.
4. Push tank fill cover inward to
close.
5. When water tank is empty,
the add-water indicator will
illuminate.
6. Place iron base on a firm
surface, such as a countertop
or on the floor. Do not place
iron base on an ironing
board.
7. Plug into outlet.
4
How to Set the Temperature
1. Set temperature dial
located below the handle
by turning clockwise or
counterclockwise until the
desired setting is in alignment
with the marker on the iron.
Select temperature based on
fabric setting chart.
2. Press ON (l)/OFF ( ) button to
turn on iron. The button will
flash green until the steam
generator is ready.
3. The preheat indicator on
the iron under the handle of
the iron will shut off when
set temperature is reached
and green flashing power
light becomes solid.
NOTE: To steam iron, make
sure to set the temperature
dial on a steam setting. If the
temperature dial is in a "no
steam" setting and the steam
blast button is pressed, the
iron may release a trail of
water.