Grease Filters - Atag WO61-AC Serie Mode D'emploi & Instructions D'installation

maintenance
cleaning

grease filters

Clean the grease filters at least once a month.
cleaning, the aluminium parts of the filters may become dull
as a result of the cleaning agents used, particularly when
placed in the dishwasher. This is normal and is not covered
by the warranty.
removing aluminium grease filter
1 Switch off the fan and lighting.
A
2 Unlock the grille (A) and hinge it downwards.
3 Push the wire brackets aside.
4 Remove the grease filter from the grille.
removing filter cassette
1 Switch off the fan and lighting.
2 Using the recess, press the filter backwards and tip it
1
downwards at the front.
2
3 Remove the filter from the hood.
cleaning
You can clean the filters in the dishwasher. Allow them to
drain fully before reinstalling them in the hood.
The filters may also be cleaned by hand.
Clean the filters in water and washing-up liquid and rinse
them. Allow the filters to drain fully. The underside of the
extractor hood can be cleaned with a mild cleaning agent and
a moist cloth. Then dry it off with kitchen towel or a dry
cloth.
GB 8
During reinstalling the aluminium grease filter
1 Place the filter in the grille.
2 Refit the wire brackets.
3 Place the grille back in the extractor hood. First press the
back into the hood; then the front. The filter will now click
A
into place.
4 Lock the filter in place by pushing the locking projections
outwards.
reinstalling filter cassette
The filter has to be installed with the locking mechanism at
the front.
Open the locking mechanism. This pulls the projections at
the front of the filter inwards. When installing the filters hold
the locking mechanism in this position.
1 Push the projections at the back of the filter into the
openings provided for this purpose at the rear of the
extractor hood.
2 Hinge the filter upwards.
3 Release the locking mechanism. The projections at the
front of the filter move outwards into the openings
provided for this purpose at the front of the extractor
hood.
The filter is now correctly positioned.
maintenance
cleaning
GB 9