Introduction; Installation Assistance; For The Home Or Business Owner; For The Installing Dealer/Contractor - Briggs & Stratton 01679-0 Manuel De L'utilisateur

Masquer les pouces Voir aussi pour 01679-0:
Table des Matières

Publicité

Briggs & Stratton Generac Generator Discount Parts Call 606-678-9623 or 606-561-4983

INTRODUCTION

Congratulations on your purchase of a Briggs & Stratton
Home Generator System (HGS).Your HGS was designed to
provide automatic auxiliary electrical power for the
duration of normal power interruption. It is not intended
for use as primary power in place of utility nor for use in
life-support applications.The generator unit has been
engineered and tested to exacting standards of
performance and reliability and is equipped with a UL®
listed Automatic Power Transfer Switch.
Briggs and Stratton has made every effort to provide for a
safe, streamlined and cost-effective installation. Because
each installation is unique, it is impossible to know of and
advise the trade of all conceivable procedures and methods
by which installation might be achieved. Neither could we
know of possible hazards and/or the results of each
method or procedure. For these reasons,
Only current qualified electrical and
plumbing contractors should attempt
HGS installations.
Installations must strictly comply with
all applicable codes, industry standards
and regulations.
Your Briggs & Stratton Home Generator System is supplied
with this "Owners Manual", a separate "Installation Manual"
(part number 190838) and a Warranty Sheet (part number
190881).These are important documents and should be
retained by the owner after the installation has been
completed.

Installation Assistance

For the Home or Business Owner:

To help you make informed choices and communicate
effectively with your installation contractor(s),
Read and understand the
Owner Orientation Section of this manual
BEFORE contracting or starting
your HGS installation.
Briggs & Stratton Power Products Home Generator System
Owners Manual
www.mymowerparts.com
To arrange for proper installation, contact the store at
which you purchased your Briggs & Stratton Home
Generator System, your dealer, or your utility power
provider.
The HGS Warranty is VOID unless the system
is installed by certified electrical and
plumbing professionals.

For the Installing Dealer/Contractor:

For most applications, the Installation manual contains all
the information required to properly install and start the
Home Generator System.This Owner's Manual describes
essential circuit selection, routine operation and owner
maintenance procedures.
If you need more information, call 1-800-743-4115,
between 8:00 AM and 5:00 PM CT.
The Emission Control System for this generator is
warranted for standards set by the U.S. Environmental
Protection Agency and by the California Air Resources
Board (CARB).

OWNER ORIENTATION

This section provides Home Generator System owners
with the information necessary to achieve the most
satisfactory and cost effective installation possible.
The illustrations are for typical circumstances and are
meant to familiarize you with the installation options
available with your Home Generator System. A thorough
understanding of these options will provide fundamental
control over the cost of your installation, as well as ensure
your final satisfaction and security.
Local codes, appearance, noise levels, fuel types, and
distances are the factors that must be considered when
negotiating with an installation professional. Remember that
as the distance from the existing electrical service and
gaseous fuel supply increases, equal compensations in piping
and wiring materials must be allowed for.This is necessary
to comply with local codes and overcome electrical voltage
drops and gaseous fuel pressure drops.
The factors mentioned above will have a direct
affect on the overall price of your Home Generator
System installation.
5

Publicité

Table des Matières
loading

Table des Matières