SEFRAM 95 Manuel D'utilisation page 13

OPERATION
Loopback test
Plug one end of the testing cable into the RJ-45 jack of
l
sourcing end on the master unit and another end of the
testing cable into the RJ-45 jack of receiving end on the
master unit.
Press the "
l
sequential scanning process if the master unit is in "auto-
scanning" mode.
Press the "
l
indicators will be alight if the master unit is in "manual-
scanning" mode.
Note: When the battery power is low, the testing results may
not be correct. Please replace with a new battery.
You can choose a auto-scanning mode or a manual-
l
scanning mode by pressing the "AUTO" button or the
"MANU" button.
The Lock function is available in "auto-scanning" mode.
l
When the loop is "OPEN", you will hear the sound of the
l
buzzer.
Remote test
Plug one end of the testing cable into the RJ-45 jack of
l
sourcing end on the master unit and another end of the
testing cable into the RJ-45 jack of the remote receiving
unit, then make tests.
Read the testing results from the LED indicator on the
l
remote receiving unit.
" button, the master unit will start a
" button, the pin1 LED lamps of the LED
- 4 -
-4-