Delta Classic Serie Instructions De Montage page 7

4
3
1
2
Important: Use two wrenches when
tightening. Do not over tighten.
1/2" (12.70mm) IPS
1 2
Supply Line Connections
For models with fittings.
Note: Be careful when bending the
copper tubing. Kinked tubes will void
the warranty. Choose hook-ups for 1/2"
I.P.S. connections: (1) Ball nose riser
(3/8" O.D. copper tubing), or (2) 1/2"
I.P.S. faucet connector. Use the enclosed
coupling nuts (3) with the ball nose risers
(1).
1/2" (12.70mm) IPS
3
7
5
1
3
Flush the System and
Check for Leaks
Remove aerator (1) and turn faucet
handle (2) to the full on mixed position.
Turn on hot and cold water supplies (3)
and flush water lines for one minute.
Important: This flushes away any
debris that could cause damage to
internal parts.
Check all connections at arrows for
leaks. Re-tighten if necessary, but do
not overtighten.
2
73858 Rev. F