Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
To turn off the appliance:
–
Press the on / off switch (1) again. The unit
is now switched off.
To install the nozzle:
The nozzles can easily be pushed over the hot
air nozzle. Never touch the nozzles during or
immediately after use of the device. The
nozzles are very hot.
Rotating handle:
The device has two handle positions (see Fig.
D) Position 1 is suitable for killing weeds and
igniting the BBQ. In position 2, the device can
be used as a hot air gun.
To change the handle position:
•
Press the release button (8)
•
Turn the handle to the desired position
•
Make sure that the release button has
been locked again.
OPTION 1: WEED KILLER
Assembly of the telescopic extension
handle:
Attach the extension handle to the device.
Make sure that the extension handle firmly
clicks into position.The telescopic extension
handle can be adjusted easily to the required
length. Turn knob A, reposition the handle to
the desired length and then turn knob A
securely.If using the device as a weed killer you
must use the extension handle.Hold the weed
killer firmly by holding the end of the extension
handle.
Use:
•
Ensure the extension handle is firmly fixed
onto the device and that the device is
turned off.
•
Turn the device to position 1 (see Fig. D)
•
Install the nozzle (11) to destroy weeds.
•
Insert the plug into the socket
•
Check to ensure the nozzle is not blocked
before turning the device on.
•
Set the temperature to setting II or III.
7063002-Maxxheat-II-Ma-1712-21.indb 9
•
Allow the device about 45 seconds to
warm up.
•
To eliminate weeds, hold the nozzle over
the weeds for about 5 seconds. During
these 5 seconds the cell structure of the
weed is destroyed. As a result, the weed
dies within a few days.
•
It is not necessary to completely burn the
weeds, 5 seconds is more than sufficient.
•
For an efficient treatment the nozzle
should be held around 0 to 5 cm above
the weeds
•
The effects are not visible immediately but
will take a while before they can be seen. It
is more of a long-term effect.
OPTION 2: SPECIFIC WEED KILLER
•
Ensure the extension handle is firmly fixed
onto the device and that the device is
turned off.
•
Turn the device to position 1 (see Fig. D)
•
Install the Heat-pin (15) to heat-treat the
weed.
•
Insert the plug into the socket.
•
Set the temperature switch in position "III".
•
Allow the device about 60 seconds to
warm up.
•
Position the heat-pin in the middle of the
weed, and push the pin into the weed, up
to the mark, and retract the heat-pin from
the soil after about 2 seconds.
•
The effect of the treatment will not be
immediately obvious as it can take several
days before it is visible, but it will have a
long-term effect.
•
Use the heat-pin only on the lawn and
loose soil. Do not use on rocky soil as the
heat-pin could break off.
•
On some occasions, a small brown spot of
burned grass can occur, but this will
recover very soon.
OPTION 3: PAINT REMOVAL
The paint removal is always done without the
use of the extension handle. Remove the
extension handle by pressing and releasing
button (7) and pulling the extension handle
from the device.
.
English
9
04-01-18 10:56
Publicité
Table des Matières
