Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
.
English
•
Hold the appliance by insulated gripping
surfaces only, because the metal heating
head may contact hidden wiring or its own
cord.
Immediately switch off the appliance
when:
•
Plug and/or cable are defective or
damaged;
•
The switch is defective;
•
You smell or see smoke caused by
scorched insulation from the hot air gun.
Electrical safety
When using electric machines always observe
the safety regulations applicable in your coun-
try to reduce the risk of fire, electric shock and
personal injury. Read the following safety
instructions and also the enclosed safety
instructions.
Always check that the power supply
corresponds to the voltage on the
rating plate.
Class II machine – Double insulation
– You don't need any earthed plug
Replacing cables or plugs
If the power cord is damaged, it must be
replaced by the manufacturer or its service
agent or a similarly qualified person, in order to
avoid a hazard.
Immediately throw away old cables or plugs
when they have been replaced by new ones. It
is dangerous to insert the plug of a loose cable
in the wall outlet.
Using extension cables
Only use an approved extension cable suitable
for the power input of the machine. The mini-
mum conductor size is 1.5 mm
cable reel always unwind the reel completely
Inadequate extension cords can be danger-
ous. If an extension cord is used, it shall be
suitable for outdoor use, and the connection
has to be kept dry and off the ground. It is
recommended that this is accomplished by
means of a cord reel which keeps the socket
at least 60 mm above the ground.
8
7063002-Maxxheat-II-Ma-1712-21.indb 8
CONTENTS
1 Weed Killer
1 Nozzle for surface weed control
1 Heating pin for underground weed control
2 Nozzles for paint removal
1 Nozzle for BBQ
1 Extension handle (2 parts)
1 Instruction manual
PRODUCT
Fig. A
1.
On / off switch
2.
Temperature switch
3.
Ventilation openings
4.
Hot Air nozzle
5.
Extension handle
6.
Handle
7.
Lock button for extension handle
8.
Lock button for revolving handle
9.
Cap
10. Stand
11. Nozzle for surface weed control
12. Flat nozzle for paint removal
13. Glass protection nozzle for paint removal
14. BBQ / fireplace nozzle
15. Heating pin for underground weed control
OPERATION
Temperature settings:
With the temperature switch you can select
. When using a
2
from three temperature settings. Depending on
the application, you can use the following
settings:
Setting I 50 °C (venting / cooling)
Setting II 400 °C
Setting II 600 °C
The volume of air in each setting 500L /Minute
To turn on the power:
–
Press the on / off switch (1)
Always use with caution! Do NOT
cover the ventilation openings during
use as it causes a risk of burns!
Do not touch the hot nozzle!
04-01-18 10:56
Publicité
Table des Matières
