AquaScape 78332 Instructions Et Entretien

I N S T A L L A T I O N
AQUAGARDEN
PLANT LIGHT
B
2
Contents – #78332
No. Description
1. AquaGarden Plant Light
B
AquaGarden Plant Light
2.
Transformer
AquaGarden Plant Light Specs
Fixture Dimensions
Stand Dimensions
Lumens
Wattage
A
Voltage Min – Max
A
Kelvin Temperature
Bulb Life
REV DESCRIPTION NAME DATE
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN
Cord Length
THIS DRAWING IS THE SOLE
PROPERTY OF AQUASCAPE INC.
ANY REPRODUCTION IN PART OR
AS A WHOLE WITHOUT THE WRITTEN
PERMISSION OF AQUASCAPE INC IS
1 PROHIBITED.
DRAWING CREATION
EAK 09/17/20
2
Safety Information
WARNING: It is recommended whenever working
in or near water to have all electrical devices
plugged into a ground fault circuit interrupter
(GFCI) that has been installed by a licensed
electrician.
• To reduce the risk of electrical shock or damage to the
light, all wiring and junction connections should be made
per local codes. Requirements may vary depending on
usage and location.
• The power cable should be protected at all times to avoid
punctures, cuts, bruises, and abrasion.
• Operating the light fixture outside of the 9-15 volt
operating range voids the product warranty and may
damage or shorten the life of the LEDs.
IMPORTANT: Aquascape, Inc. is not responsible
for losses, injury, or death resulting from a failure to
observe these safety precautions, misuse or abuse
of pumps or equipment.
facebook.com/aquascapeinc
youtube.com/aquascape4
pinterest.com/aquascapeinc
B
1
A
REV DESCRIPTION
3.75" dia. x 2.8" H / 9,53 cm x 7,11 cm
8" W x 18.5" H / 20,32 cm x 47 cm
1,000
1
DRAWING CREATION
8-Watts +/- 10%
9V – 15V
5,000
50,000 hours
UNLESS OTHERWISE SPECIFIED:
CREATED BY EAK CREATED DATE
DIMENSIONS ARE IN INCHES
CHECKED BY CHECKED DATE
TOLERANCES:
8.2' / 2,5 m
FRACTIONAL 1/16
ANGULAR: MACH 5 BEND 5
TWO PLACE DECIMAL .010
THREE PLACE DECIMAL .005
REV DESCRIPTION NAME
INTERPRET GEOMETRIC TOLERANCING PER: ANSI
1
DRAWING CREATION EAK
I N S T R U C T I O N S
2
Installation
STEP 1
CONNECT TO
AQUAGARDEN
• Remove the plug at the
back of the waterfall filter,
then insert the light as
shown (Ex. 1).
1
STEP 2
CONNECT THE LIGHT
NOTE: TITLE BLOCK TOLERANCE
NOT APPLICABLE
• Connect the light to the
included, AquaGarden Plant
Light Transformer (Ex. 2).
2
STEP 3
PLUG IN TRANSFORMER
• Plug the transformer into a GFCI-protected outlet.
NOTE: Keeping the light on for excessive periods of time
can lead to issues with water quality and algae growth.
NAME DATE
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN
We recommend setting up the light to turn on and off
THIS DRAWING IS THE SOLE
PROPERTY OF AQUASCAPE INC.
automatically.
ANY REPRODUCTION IN PART OR
AS A WHOLE WITHOUT THE WRITTEN
• To automatically turn the light on/off, use the Aquascape
PERMISSION OF AQUASCAPE INC IS
PROHIBITED.
EAK 09/17/20
Smart Control Plug (#82001) for dynamic scheduling
2
on your smartphone or tablet, or use our simple Quick-
Connect Photocell with Timer (#84039).
TITLE:
09/17/20
AQUAGARDEN PLANT LIGHT Troubleshooting
DWG. NO.
78332-DE-AP-MM-AQUAPL
• Light won't turn on
SCALE: 1:5 SIZE SHEET 1 OF 1
DATE A UNLESS OTHERWISE SPECIFIED:
PROPRIETARY AND CONFIDENTIAL
– Make sure the quick-connect fitting is fully connected
1
THE INFORMATION CONTAINED IN DIMENSIONS ARE IN INCHES
THIS DRAWING IS THE SOLE
TOLERANCES:
– Make sure the outlet is receiving power and the GFCI is not tripped
PROPERTY OF AQUASCAPE INC.
FRACTIONAL 1/16
ANY REPRODUCTION IN PART OR
ANGULAR: MACH 5 BEND 5
– Verify that the transformer and timer or Smart Control Plug are
AS A WHOLE WITHOUT THE WRITTEN
TWO PLACE DECIMAL
PERMISSION OF AQUASCAPE INC IS
functioning properly THREE PLACE DECIMAL
PROHIBITED.
09/17/20
2
Replacement Parts
AquaGarden Plant Light Replacement Parts
No. Item number/description
1. 99072 – AquaGarden Plant Light Transformer
Warranty Information
Aquascape warrants that the AquaGarden Plant Light will be free of manufacturing
defects for one year from date of purchase. Proof of purchase required. Warranty
does not cover damage resulting from negligent handling, misuse, or lack of
reasonable maintenance or care. If upon Aquascape's inspection, the light
shows evidence of a manufacturing defect, Aquascape's liability is limited, at
Aquascape's option, to the repair of the defect, or the replacement of the
defective product or refund of the original purchase price. The warranty excludes
costs of labor, removal of product, shipping and expenses related to the installation
and re-installation of the product. No liability for loss or damaged of any nature
or kind, whether arising out of or from the use of the product, whether defective
or not defective, is assumed by Aquascape, Inc. or its affiliates. Aquascape shall
not be liable for any incidental, consequential, or other damages arising under
For more information about our company or products, please visit our website at
aquascapeinc.com or call us at US (866) 877-6637 CAN (866) 766-3426
B
UNLESS OTHERWISE SPECIFIED: CREATED BY
DIMENSIONS ARE IN INCHES
CHECKED BY
TOLERANCES:
FRACTIONAL 1/16
ANGULAR: MACH 5 BEND 5
TWO PLACE DECIMAL .010
THREE PLACE DECIMAL .005
INTERPRET GEOMETRIC TOLERANCING PER: ANSI
A
CREATED BY
EAK
CHECKED BY CHECKED DATE
.010
.005
INTERPRET GEOMETRIC TOLERANCING PER: ANSI
ONE YEAR WARRANTY
any theory of law whatsoever.
©2020 Aquascape, Inc. • All Worldwide Rights Reserved
1
NOTE: TITLE
NOT APPLI
Ex. 1
Ex. 2
CREATED DATE
EAK 09/17/2
CHECKED DATE
TITLE:
CREATED DATE
09/17/20
AQUAGA
DWG. NO.
78332-DE
SCALE: 1:5
1
09/20