Important; Before Use - Prem-I-Air Elite EH1396 Mode D'emploi

IMPORTANT

Installer and Users please note:
These instructions should be read carefully and left with the user of the product for future
reference.

BEFORE USE

You must inspect the appliance including its cable and plug for any signs of damage. If the
product is damaged, DO NOT use it, and contact your supplier immediately..
INSTALLATION
To desk-mount – attach the D-shaped plastic foot to the underneath of the product – the
flat side goes towards the front, the set of nearest the front insert into the holes on the
underneath of the product.
To wall-mount – drill a hole in the wall and insert a wall-plug. Insert a No.6 woodscrew and
tighten until the screw head is 5 mm proud of the wall. Hang the product on the screw using
the key-hole slot.
OPERATION
To change the display mode
Press the MODE button once to display the date
Press the MODE button again to display the alarm time
To set the time
Press and hold the MODE button for 3 seconds to enter Time Setting mode.
The hours digits will now flash: Press UP or DOWN to change the hours as required.
Then press the MODE button again. The minutes digits will then flash. Press UP or DOWN
to change the minutes as required.
Finally, press "MODE" to confirm.
To set the Alarm time
Press the "MODE" button twice to display the alarm time.
Press and hold the MODE button for 3 seconds to enter Alarm Setting mode.
The hours digits will now flash: Press UP or DOWN to change the hours as required.
Then press the MODE button again. The minutes digits will then flash. Press UP or DOWN
to change the minutes as required.
Finally, press "MODE" to confirm.
To set the Date
Press the "MODE" button once to display the date.
Press and hold the MODE button for 3 seconds to enter Date Setting mode.
The months digits will now flash: Press UP or DOWN to change the month as required.
Then press the MODE button again. The day digits will then flash. Press UP or DOWN to
change the day as required.
Finally, press "MODE" to confirm.
The day of the week is set automatically.