Step 5: Connect Power Supply To Booster - Wilson Electronics Weboost DRIVE REACH Guide D'installation

______
Step 5: Connect Power
Supply To Booster
Connect the power supply cord to the end of the booster,
labeled "12V DC", then plug the power adapter into vehicle's
12V DC power supply. The Drive Reach will automatically power
on when plugged in. If your Drive Reach is working correctly,
the light on the booster will be green. Use only the power
supply provided in this package.
NOTE: If the 12V cigarette lighter port on your car is always on (even when
your vehicle is turned off) and you will be parking for extended periods of
time (more than a day), we recommend you turn the booster off by switching
the rocker to the "OFF" position. This will prevent the Drive Reach from
draining the battery in your vehicle.
connect Power
Supply Cord
DRIVE REACH VEHICLE SIGNAL BOOSTER
plug into vehicle's 12V DC
Power Supply
7