Johnson Outdoors MINN KOTA MKA-51 Guide D'installation page 7

4
NOTICE:
The Stainless Steel Screws (Item #4),
Flat Washers (Item #10) and Nylock Nuts
(Item #6) that came with the Quick Release
Bracket are not used when installing the
MKA-51 to an Ulterra. Instead, the Hex Head
Bolts (#2203431) the Clipped Washers
(#2201725) included in the mounting hardware
that came with the Ulterra motor should be used.
NOTICE:
To prevent seizing of the stainless steel
hardware, do not use high speed installation tools.
Wetting the screws or applying an anti-seize may
help prevent seizing.
e. Install the Top Plate Assembly to the motor using
three Hex Head Bolts (#2203431) and three Clipped
Washers (#2201725). The Screws should pass
through the Clipped Washer and into the Top Plate.
Leave at least 1/4" space between the Hex Head
Bolt and Clipped Washer in order to slide the Base
Extrusion under the Clipped Washer and into place.
5
f. Slide the Base Extrusion into place under the Bolts
that were just installed.
g. The Base Extrusion should slide between the Top
Plate and the Clipped Washers. Hold the Clipped
Washers up on the Stainless Steel Screw, so the
Clipped Washer will sit on top of the Base Extrusion.
7 | minnkotamotors.com
4e
Clipped Washer Clipped Washer
CAUTION
Use extra care to avoid pinching and damaging the sensor wires
that run alongside of the Base Extrusion when installing and
tightening the motor mounting bolts.
5g
Top Plate Top Plate
Hex Head Hex Head
Bolt Bolt
Top Plate Top Plate
Power Tilt Power Tilt
Base Base
Clipped Clipped
Extrusion Extrusion
Washer Washer
©2020 Johnson Outdoors Marine Electronics, Inc.