Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2
c.
Remove the four Sideplate screws using a #3
Phillips screwdriver. Two of these screws will be
located on each side of the mount.
d.
Remove the Right Sideplate.
e.
Swing the Left Sideplate out and away from the
Base Extrusion. Removing the sideplates exposes
the mounting holes in the Base Extrusion.
2d
Mounting Holes
Mounting Holes
3
ITEM(S) NEEDED
f.
Take the Electric-Steer Quick Release Bracket
Assembly (Assembly #B and #C) and remove the
Pin. Open the Cam Lever and slide the Top Plate
away from the Bottom Plate until they are separate.
Set the Bottom Plate aside.
g.
On the Top Plate, take note of the Cam Lever
attached to the plate. When the Top Plate is
attached to the Base Extrusion, the end with the
Cam Lever will mount on the same end the Power
Cord exits the base of the Mount.
NOTICE:
The Cam Lever will only open and close in
one direction.
3 | minnkotamotors.com
Right Sideplate
Right Sideplate
#B x 1
2c
2e
Base Extrusion
Base Extrusion
#C x 1
Top Plate
Top Plate
Bottom Plate
Bottom Plate
Sideplate Screws
Sideplate Screws
Cam Lever
Cam Lever
©2020 Johnson Outdoors Marine Electronics, Inc.
Pin
Pin
Publicité
Table des Matières
