Hornbach 10530794 Mode D'emploi page 148

NOTE
We recommend that assembly be carried out by two people in order not to damage the
heating panel.
Before assembly
1. Open the box and take out the appliance.
2. Remove all packaging from the appliance.
3. Next, check the appliance for any damage.
4. Carefully unwind the power cable and check it for damage too.
Wall mounting
1. Mark the spots where four holes are to be drilled on the wall. (It is best to install the heater 20 to
100 cm from the floor).
2. Use the drill bit from the accessory package to drill the holes.
3. Insert the plastic aligners in the holes.
4. Attach the heating panel to the four aligners that line up with the four holes in the heater.
5. Screw the four mounting bolts in the plastic aligners.
6. Put the caps on top of the mounting bolts. We recommend using regular glue to glue the caps
to the bolts.
7. To remove the appliance from the wall, simply take off the screw caps and unscrew the bolts
with a screwdriver.
148