Endura IDS 393243A Directives D'installation Et D'utilisation

393243A (ABS)
393243AW (PVC)
Installation Instructions:
The Endura® IDS can be installed either horizontally or vertically and can be used to provide a water seal
trap, thereby replacing the need for a P-Trap. Provided 'loose assembled' the inlet and outlet can be
orientated to best suit your application, both hubs accepting 1-1/2" DWV pipe.
When making your installation, ensure that at least 8" of clearance remains in the direction of the filter
screen removal. Once confirmed in its final orientation, the two main body are solvent welded using
Replacement Filter and
regular pipe jointing cement. Note: If joining ABS to PVC, a suitable transition cement must be used.
Access Cap Assembly
393243AR (ABS)
For connection to the inlet and outlet hubs, the same holds true and should you require to make
393243AWR (PVC)
connection to other tubular materials, a full range of trap adaptors are also available from Endura®.
Operation Instructions:
Once installed and operational, the IDS is cleaned by removing the access
cap. This is unscrewed in an anti-clockwise direction. As it is removed the
filter screen, assembled as an integrated part of the cap, self cleans the
inside surface of the IDS. Clean the accumulated debris and refit the filter
screen and cap.
Cleaning frequency is entirely dependant on application but typically a
noticeable slowing of your drainage discharge will be evident and indi-
cate the requirement for cleaning.
Depending on the orientation of your final installation (P-trap configura-
tion for instance), the unit may contain a quantity of waste water, so
be sure to have a suitable container to hand to
catch any spillage upon opening. The filter
screen and cap are replaced in the reverse manner
of opening, ensuring that the O-ring seal
Technical Support
tech-support@endurainterceptor.com
Endura® is a registered trademark.
on the access cap remains in place and
in good condition. Hand tighten only.
Canada
Tel: (705) 726-3361
1-800-461-1771
Fax: (705) 726-2186
Installation and Operation Instructions
Thank you for purchasing the Endura® InLine Drain Strainer.
The Endura® IDS is intended for installation on individual
sink wastes in kitchen and sanitary applications, or where
there are materials or objects that need to be prevented
from entering the drainage system. These may be such
things as, but not limited to food debris, hair, lint or even
valuable items such as jewelry.
IDS VERTICAL (P-TRAP CONFIGURATION) IDS HORIZONTAL WITH P-TRAP
SINK
VENT
HORIZONTAL
VERTICAL
STRAINER
STRAINER IN
P-TRAP POSITION
IDS HORIZONTAL (P-TRAP CONFIGURATION) IDS HORIZONTAL WITH ALTERNATE P-TRAP
SINK
VENT
HORIZONTAL
STRAINER IN
P-TRAP POSITION
U.S.A.
Tel: (303) 373-1918
1-888-461-5307
Fax: (303) 373-1923
IDS VERTICAL (P-TRAP CONFIGURATION)
SINK
VENT
VERTICAL
STRAINER IN
P TRAP
P-TRAP POSITION
IDS HORIZONTAL (P-TRAP CONFIGURATION)
SINK
VENT
HORIZONTAL
STRAINER IN
P TRAP
P-TRAP POSITION
393243A-5
01/16
IDS HORIZONTAL WIT
SINK
VENT
HORIZONTAL
STRAINER
IDS HORIZONTAL WITH ALTE
SINK
VENT