Optional Accessories - Oase UST 150 Notice D'emploi

Installation
The unit is supplied completely fitted. Bolt the unit to the ground to ensure firm seating. Position the unit such that it
does not present a hazard for anybody. When locating outside of the water, keep a minimum safety distance of 30 cm
from combustible material.
On the secondary side, connect the transformer using (see accessories) with the OASE spotlight Lunaqua 10 LED and
Halogen. Remove the blind cap for each of the plug connections to be assigned. Refit the remaining blind covers to the
transformer. Plug the cable sets to the free connection points. Tighten the connection screws. Connect the cable ends
to the spotlight. Connect the transformer to the mains, then check the spotlight function. Please refer to the sketch if
you want to use existing older sets of cables or spotlights of the Lunaqua 10 series.
Adhere to the operating instructions given for the spotlight and the cable set. Attention: The installed lamp capacity
must not exceed the transformer rating indicated on the type plate.

Optional accessories

Lunaqua 10, OASE 7.5 m cable set, OASE 5 m cable set, OASE 2.5 m cable set, 12 V / 35 W bulb, 12 V / 50 W bulb,
12 V / 75 W bulb.
Lunaqua 10 LED, connection cable 2.5 m / 5 m / 7.5 m of the 01 series, replacement bulb Lunaqua 10 LED.
Cleaning
Attention! Dangerous electrical voltage.
Possible consequences: Death or serious injuries.
Protective measures: Always switch the unit voltage free and secure against switching on again prior to
working on the unit.
Cleaning the unit
If necessary, clean the unit with clear water using a soft brush.
Repair
In the event of damage to the cables or the housing, the unit cannot be repaired and, therefore, has to be replaced.
Disposal
Do not dispose of this unit with domestic waste! For disposal purposes, please use the return system provided.
Disable the unit beforehand by cutting off the cables.
13389-07-13_GA_Trafo UST 150.pdf5 5
- GB -
30.07.2013 08:27:25
5