Redline RN-9032 Guide Rapide page 6

3.
Secure the disks on the mounting plate. Fix the screws according to the figure
below. Avoid damaging the disk in the process.
4.
Put the mounting plate back in place. Connect the power cables and data cables
as shown in the figure. Repeat the steps to connect all the disks.
Data cable
5.
Put the cover back in place, and secure it and the mounting plates with screws.
Device with disk bracket

1.
Fasten the disks to the brackets.
2.
Fasten the brackets installed with hard disks to the device.
Power cable
5