Redline RN-9032 Guide Rapide page 5

5.
Put the cover back in place and tighten the screws.
4.3
4 or 8 HDD Installation
4.3.1 Remove Upper Cover
1.
Loosen the screws on the upper cover.
2.
Slide the upper cover backward, then lift it up to remove the cover.
4.3.2 Install Disks
The installation steps for devices with mounting plate and disk bracket are different.
Choose the installation method according to your device model.
Device with mounting plate

1.
Loosen the screws of the mounting plate on the side panels.
2.
Turn the upper mounting plate in the shown direction, then remove the plate.
Repeat the steps to remove the lower mounting plate (for 8-HDD devices only).
4