FITTING THE OVEN INTO THE KITCHEN UNIT
Fit the oven into the space provided in the kitchen unit; it may be
fitted underneath a work top or into an upright cupboard. Fix the
oven in position by screwing into place, using the two fixing holes in
the frame. To locate the fixing holes, open the oven door and look
inside. To allow adequate ventilation, the measurements and
distances adhered to when fixing the oven.
IMPORTANT
If the oven is to work properly, the kitchen housing must be suitable.
The panels of the kitchen unit that are next to the oven must be
made of a heat resistant material. Ensure that the glues of units that
are made of veneered wood can withstand temperatures of at least
120 ºC. Plastics or glues that cannot withstand such temperatures
will melt and deform the unit, once the oven has been lodged inside
the units, electrical parts must be completely insulated. This is a legal
safety requirement.
All guards must be firmly fixed into place so that it is impossible to
remove them without using special tools. Remove the back of the
kitchen unit to ensure an adequate current of air circulates around
the oven. The hob must have a rear gap of at least 45 mm.
DECLARATION OF COMPLIANCE
When you have unpacked the oven, make sure
that it has not been damaged in any way. If
you have any doubts at all, do not use it:
contact a professionally qualified person.
Keep packing materials such as plastic bags,
polystyrene, or nails out of the reach of children
because these are dangerous to children.
4
V.3