Kichler 49738OZ Instructions

1) TURN OFF POWER.
a) IMPORTANT: Before you start, NEVER attempt any work
without shutting off the electricity until the work is done.
b) Go to the main fuse, or circuit breaker, box in your
home. Place the main power switch in the "OFF"
position.
c) Unscrew the fuse(s), or switch "OFF" the circuit breaker
switch(s), that control the power to the fixture or room
that you are working on.
d) Place the wall switch in the "OFF" position. If the fixture
to be replaced has a switch or pull chain, place those in
the "OFF" position.
2) Find the appropriate threaded holes on mounting strap.
Assemble mounting screws into threaded holes.
3) Attach mounting strap to outlet box. Mounting strap can be
adjusted to suit position of fixture.
4) Make wire connections. Reference chart below for correct
connections and wire accordingly.
Connect Black or
Red Supply Wire to:
Black
*Parallel cord (round & smooth)
Clear, Brown, Gold or Black
without tracer
Insulated wire (other than green)
with copper conductor
*Note: When parallel wires (SPT I & SPT II)
are used. The neutral wire is square shaped
or ridged and the other wire will be round in
shape or smooth (see illus.)
5) Carefully push wire connections back into outlet box making
sure all connections remain secure.
6) Push fixture to wall, carefully passing mounting screws
through holes.
7) Screw threaded balls onto mounting screws. Tighten
threaded balls to secure fixture to wall.
8) Insert recommended bulbs (Not included). Sockets are ac-
cessible through glass door. To open glass door, raise latch
up and pull.
INSTRUCTIONS FOR MOUNTING
FIXTURE OUTDOORS AND/OR IN WET LOCATIONS.
9) Mounting surface should be clean, dry, flat and 1/4" larger
than the canopy on all sides. Any gaps between the mount-
ing surface and canopy exceeding 3/16" should be cor-
rected as required.
10) With silicone caulking compound, caulk completely around
where back of canopy meets the wall surface to prevent
water from seeping into outlet box.
Date Issued: 04/13/16
INSTRUCTIONS
For Assembling and Installing Fixtures in Canada
Pour L'assemblage et L'installation Au Canada
Connect
White Supply Wire to:
White
*Parallel cord (square & ridged)
Clear, Brown, Gold or Black
with tracer
Insulated wire (other than green)
with silver conductor
Neutral Wire
BULB
(NOT INCLUDED)
AMPOULE
(NON INCLUS)
CANDLE
SLEEVE
MANGA
DE LA
VELA
SEE OTHER SIDE FOR CANADIAN FRENCH TRANS-
LATIONS.
VOIR L'AUTRE CÔTÉ POUR LES CANADIENS TRA-
DUCTIONS EN FRANÇAIS.
866-558-5706
We're here to help
Hrs: M-F 9am to 5pm EST
SLOTTED
LOCK-UP KNOB
PERILLA DE
BLOQUEO RANURADA
MOUNTING SCREW
MOUNTING STRAP
CORREA DE MONTAJE
MOUNTING SCREW
DE MONTAJE
LATCH
PESTILLO
GLASS DOOR
PUERTA DE
CRISTAL
STRAP
CORREA DE
TORNILLO
DE MONTAJE
WIRE NUT
TUERCAS DE
MARIPOSA
TORNILLO
IS-49738-CB