Programming With Lsm Starter; Programming With Mobilekey; Programming Distance - Simons Voss Technologies CD.STARTER.G2 Guide Abrégé

6. Programming

6.1 Programming with LSM STARTER

The current version of LSM 3.2 or higher must be installed on your
computer. Connect the USB config device. Place the components to be
programmed at a distance of 10-30 cm from the programming device
and implement the programming routines.
If you should receive an error message stating that no hardware has
been found, first check that the USB config device is connected properly
and then verify whether the CDStarter has been detected under
'Programming / Config device' in the software. If there is still an error
message, remove the programming device from the USB socket and
plug it in again. The driver will then be reloaded.

6.2 Programming with MobileKey

Log on to the web application and select "Menu/Programme" . The
programming app must be installed to programme with the web
application. The set-up file is provided for download via a link.
If the programming app is already installed, you can launch it directly
using the "START APP" button and then begin programming.

6.3 Programming distance


20 / 76
The distance between the USB config device and active
components, such as locking cylinders or transponders, should be
about 20 cm.
(MK.)CD.STARTER.G2
EN