GRAUPNER LiPo Balancer 6 Plus Instructions D'utilisation page 13

A brief summary of the LiPo Balancer 6 plus
A brief summary of the LiPo Balancer 6 plus
10A fuse
STATUS LED
MODE/RESET
MASTER/SLAVE-Switch
Series connection of two balancers
- First set the Master/SLAVE-Switch of the Master-Balancer to position M and of the SLAVE-Balancer
to postion S.
- Connect the red charger cable of the Master-Balancer and the black charger cable of the Slave-Ba-
lancer with two soldered and shrinked 4mm gold connectors (female).
- Connect the black charger cable of the Master-Balancer to BATT. (-) of the LiPo-charger and the red
charger cable to the Slave-Balancer to BATT. (+) of the LiPo-Charger.
- Connect the network cable between the two balancers.
- Connect the two LiPo battery packs (Balancer plug and high-current connectors) within 12 seconds
to the Master balancer and Slave balancer (see figure!). If the LiPo pack is not connected to the slave
balancer within 12 seconds, only the Master balancer will work alone. In this case, disconnect both
LiPo-batteries completely and connect them again. During the 12 seconds Initial Mode, the STATUS
LED will flash on time per second until the balancers did initalize the battery configuration.
NETWORK CABLE
Individual cell OUTPUT:
for connection to the
GRAUPNER multi-pin LiPo
measuring lead.
Charger INPUT: only one
of the two connector sets
may be connected to the
charger!
OUTPUT: for connection to
the high-current connec-
tors of your LiPo battery.
!! Only one of the two
connector sets may be
used !!
LiPo Balancer 6 plus summary 13