Power Fist 8970444 Manuel D'utilisateur page 6

8970444
IDENTIFICATION KEY
A Burner
B Drip- Pan
C Body
D Electronic Ceramic Needle
E Pressure Sensor-Lock Lever
OPERATION
Letter references in parenthesis (A) refer to the included Identification Key.
1. Ensure the switch (F) is set to OFF.
2. Flip the pressure sensor-lock lever (E) to UNLOCK.
3. Flip the side panel (I) down on one or both sides, depending if you are using
one or both burners. Insert your finger into the panel's hole to open it.
4. Insert the butane gas cartridge into the valve (H) and ensure it is properly
seated. The arrow on the valve lines up with the notch in the butane
cylinder's collar.
5. Flip the pressure sensor-lock lever to LOCK. This will seal the butane
cylinder in place.
a. The pressure sensor-lock lever will only lock when the drip-pan
supports are properly installed and the switch is in the OFF position.
6. Check that the seal is tight. Turn the switch to allow gas to flow. Apply
soapy water to the valve, brass tube and around the burner (A). Watch for
6
Two-Burner Butane Stove
F
G
H
I
For technical questions call 1-800-665-8685
Switch
Auto Gas Shut-Off Safety Device
Valve
Side Panel
V4.0
Fig. 1