Sealy EASE Guide D'installation Rapide

EASE
Adjustable Base Parts List
Wireless Remote
Control
AAA Batteries (3)
*attached to the base for shipping
Miscellaneous Parts (not included): Surge Protector (1) , 9 Volt Batteries (2)
All electronics and components that need to be installed are located in boxes under the base or attached to the frame.
STEP 1
Place the bed base box in a desired location with the bottom of
the box facing up.
Remove the binding straps and packing materials, making sure not
to puncture the box with any sharp objects.
STEP 2
Remove the bed base from the box. Unfold the bed making sure to
keep the bottom of the bed facing upwards.
STEP 3
To install Headboard Brackets
(sold separately) see instructions
on page 12 of the Owner's Manual.
To install the legs, thread the leg into
the frame, and tighten by hand. Do
not over tighten.
STEP 4
To sync two bases see detailed installation
instructions on pages 10-11 of the Owner's Manual.
It is recommended to leave the battery backup strap attached
to the power supply for use when needed. 2 9V batteries (not
included) will be required for its use.
STEP 5
Uncoil Input Cord (connected to
Control Box's power port) and plug
into Power Supply.
For customer support, call Customer Service: US 1-800-499-1965 | Canada 1-800-268-4414
®
Mattress
Legs (6)
Retainer Bar*
Quick Setup Guide
Always use two people when setting up the base.
Power
Power Cord
Supply
STEP 6
Uncoil the Power Cord and connect it to
the Power Supply. Place Power Supply
on the ground and extend from the
base. Ensure that the Power Supply and
all attached cords are directed to the
desired surge protector.
STEP 7
Carefully flip the base over on to its legs. Important: Two people
are required to move the bed base. Do not drag across the floor.
Do not rest frame on its side, excessive pressure may damage the
legs.
STEP 8
Plug the Power Cord into a power source. A surge protector is
recommended.
STEP 9
Ensure that batteries are correctly installed in the remote. Quickly
test remote functions to verify proper setup before placing
mattress on base. Return the base to a FLAT position before
placing the mattress on top.
STEP 10
To install the mattress retainer bar, insert each end of the bar into
the holes at the foot of the platform.
STEP 11
Give Remote - Quick Use Guide to customer. Ask them to read the
Warning and Use Instructions to see if they have any questions.
Advise them to store the Remote - Quick Use Guide for future
reference.
Setup is now complete! Test all functions on remote.
Battery Backup Remote - Quick
Strap Use Guide
V004_1/2022