Charging The Battery; Switching On And Off; Pairing With A Bluetooth Device - Trevi ELEGANCE DJ 1200 BT Mode D'emploi

ENGLISH
To avoid possible hearing damage, limit the time listening at high
volumes.
DESCRIPTION OF CONTROLS AND ACCESSORIES
1. Power button on / off / play / pause
2. NEXT button, the next track / volume increase
3. PREV button, previous track / volume down
4. MicroUSB port for charging
5. LED indicator
6. AUX IN
7. Microphone
Accessories: Jack / Jack stereo cable for connection to devices with Audio Out jack, micro USB cable to charge the
headset multifunction HiFi to devices with USB ports.

CHARGING THE BATTERY

Multifunction HiFi headphones have an internal rechargeable battery.
The first time you use the headphones, charging for a 3-4 hours; Fully charging the headphones have a range of about
2 hours in music listening.
Charge the battery:
- Connect the micro USB cable supplied to an external device equipped with a USB socket (computer, tablet ...) or a
power supply with 5V
- Connect the microUSB cable supplied with HiFi headphones into the connector (4); during charging the LED
indicator (5) will turn red.
- When charging is completed the LED indicator (5) will go off.
- When the battery is 20% charged, the headset HiFi will issue a warning.

SWITCHING ON AND OFF

Press and hold the On / Off button (1) to turn the unit. You will hear the voice message "Power ON".
Press and hold the On / Off button (1) to switch off the set. You will hear the voice message "Power OFF".

PAIRING WITH A BLUETOOTH DEVICE

1. Turn on the unit. The LED indicator (5) will start to flash alternately red and blue.
2. Enable the Bluetooth connection of the external device (Smartphone, Tablet, etc. ...) referring to its manual.
3. From the external device to perform a search of devices and select "DJ TREVI 1200 BT" or "BT001"; If prompted,
type the code "0000".
4. When the connection with the external device will place the LED (5) will flash slowly.
Note: A paired device, it may happen that the connection is interrupted (such as when the devices connected via
Bluetooth stray too far from each other); Normally the connection is automatically restored, otherwise it is necessary
to perform the pairing procedure again from step 1 to 4.
Whenever you want to pair your headset to a new device, you need to make a new pair by repeating the above
procedure from step 1 to step 4.
During pairing the two devices must be placed at a distance less than one meter, in normal use, the maximum distan-
ce for proper operation is about 8 meters.
CABLE CONNECTION TO AN EXTERNAL DEVICE
You can use the headset as normal wired headphones by connecting them to an external device with the Jack / Jack
stereo cable supplied:
1. With headphones turned off, connect a cable to the headphone jack using the AUX IN jack (6), connect the other
jack into the HEADPHONES socket of device.
USB socket (not supplied).
PAG.5
DJ 1200 BT