Beper P202VAL001 Mode D'emploi page 14

10in1 Cleaner and Sanitizing Mop Use Instructions
Product desctiption fig.A
1. Glass and window accessory
2. Towel
3. Brush sprayer
4. Round brush spayer
5. Bent sprayer
6. Funnel
7. Measuring cup
8. Long sprayer
9. Extension for sprayer accessory
10. Connector nozzle
11. Microfiber cloth
12. Broom brush
13. Broom brush connector
14. 3 extension mop pole set
15. Steam and child safety button
16. Safety lid
17. Short sprayer
18. Cable
19. Indicator light
20. Tank
Instruction for use
First use
Fill in the tank before use.
Place the item on a flat and stable surface, unscrew the safety cover (turn anticlockwise).
Put the funnel inside the tank mouth.
Take 175ml of water (by using the measuring cup) and insert into the tank while using the funnel. The maximum
capacity of the tank is 350ml, please don't overfill the tank.
Put back the safety cover and screw it firmly (turn clockwise).
Refill of the tank
Do not open the safety valve when using the appliance. You could only turn on the safety valve when power is
cut and the appliance is completely cooled down. Press the steam button to reduce the pressure and let all the
steam come out.
Unscrew slowly the safety lid, but do not remove it. Steam will slowly come out itself. Let the appliance cool down
for some minutes.
Remove the safety lid than follow the instructions as shown on the " first use".
Switch on
Check the electricity and the plug and make sure they match the requirements as described in the manual and
rating label, then insert the plug.Wait for the water to heat up (5-6 minutes) than steam is ready. To let steam
come out, pull forward the safety button and press the button down. Fig.B
Release the button, insert the accessories according to different use. Press the steam button again and start
cleaning.
Accessories connection
Brush and long sprayers connection
To insert the brush or long sprayer to the body, follow the arrow to screw the sprayer in clockwise way. Proceed
as indicated
in Fig.C, In order to assemble extension to all available accessories.
Round or bent sprayer connection
Insert the round or bent sprayer to the short sprayer directly by making a little press. These accessories can
be connected to the long sprayer. To disengage the bent or the round sprayer, pull, applying pressure, until it is
completely disengaged. Fig. D
14