Installation Of Accessories - Ninebot Gokart Pro Manuel De L'utilisateur

4 Installation of Accessories

Install the Rear spoiler
Note: Do not press or lift the rear spoiler during installation.
a Insert the tail bracket into the tail jack.
a
R
L
Install the Ninebot Engine Speaker
a Place the base in a proper position (as shown below) and
wrap the strap around the vehicle body and fasten the
strap. Press the remaining part of the strap into the
storage slot.
a
10
b Use the 2.5 mm hex wrench to tighten the 6 screws
into the main body of the rear spoiler (See Accessory
No. 2).
b
b Align the holes on the bottom of the speaker. Press
down until you hear a "clicking" sound.
b
Remove the Speaker
Press the disassembly switch while lifting the speaker upward.
* For more information about the speaker, see the user manual of Ninebot Engine Speaker.
Disassembly and Replacement of Tires
* Only applicable to Gokart front tire.
1 Use a 19 mm wrench to remove
the middle screw.
2 Replace the tire. 3 Tighten the screw.
The cross head of the screw should face outwards.
11