Operating Instructions; Lighting; Temperature Controle; Switching Off - Dru Verwarming STYLE 3 Instructions D'installation Et Mode D'emploi

OPERATING INSTRUCTIONS

The buttons to operate the appliance have been placed
behind the flap on the heater front.

Lighting

Press and hold button A (with the
symbol ). Press the ignition but-
ton E (with the symbol
or twice to light the pilot burner.
Check that the pilot flame is alight
(behind the glass on the front).
Once the pilot light is burning, hold
button A for another 10 seconds.
Then release button A and check
that the pilot light is still burning.
The main burner could be ignited
by the pilot light immediately after
button A has been released,
depending on the thermostat setting,
button D, and the room temperature.
Temperature control
The thermostat setting, button D, will determine the
temperature in the room. Setting 7 - with '7' opposite
the indicator (C) - will give the highest temperature and
setting 1 the lowest. The thermostat regulates the heater
in modulation between HIGH and LOW burner settings
and, if only a little warmth is required, between LOW
and N.
The thermostat automatically keeps the room at the
required temperature.
There is absolutely no objection to the appliance staying
on overnight, it is fully protected.
The thermostat has a frost-protection setting. This is
setting N on the thermostat control D. If the ambient
temperature drops below 10 ºC, the valve will automati-
cally open; the heater will then heat the room to 10 ºC.
If this is not required, the heater should be switched off.

Switching off

Press button B (with the symbol o ). The gas supply to
both the main and the pilot burners is then switched off.
) once
B
C
D
13
OPERATING INSTRUCTIONS
STYLE