Publicité
Les langues disponibles
Les langues disponibles
5.
Install photocell (if used). Photocell receptacle is a
friction rotatable connector which allows adjustment
without the use of tools. Insert photocell prongs and
rotate to extreme clockwise position. To orient control,
rotate until photocell is facing the window in the access
door.
Caution: Photo control receptacle has a built-in stop
which permits 350 degrees of rotation. Do not rotate
beyond its limit.
6.
Once connections are completed and bracket installed,
carefully push all excess wires down into the tenon.
Replace access door and secure with quarter turn
screw.
7 .
To complete construction, attach lens globe over LED
light engine making sure to avoid contact between
Lens globe and LED boards. Tighten four set screws to
5-10 in-lbs. (Figure 4.)
Figure 4.
Lens Globe
LED Engine
(Do Not Touch)
1/4"-20 Set Screw (4X)
Torque: 5-10 in-lbs.
(Apply Breakable Thread
Locker)
COOPER LIGHTING SOLUTIONS
Installation Instructions – Utility LED Acorn (ULA)
Optional House Side Shield Installation
1.
Loosen four set screws making sure not to unwind
screws completely from casting.
2.
Slide lens globe off of luminaire and avoid contact
between LED light engine and lens globe.
3.
Remove two #10 hex head screws from top of LED
light engine that are oriented on the house side. Attach
house side shield on top of gasket and install screws
and tighten 5-10 in-lbs. until flush with gasket surface.
4.
To complete installation, slide lens globe over LED
light engine and apply breakable thread locker to 4 set
screws. Tighten 4 set screws to 5-10 in-lbs. (Figure 5.)
Figure 5.
IB516006EN
Lens Globe
#10 Hex Head
Screw (2X)
House Side Shield
1/4"-20 Set Screw (4X)
Torque: 5-10 in-lbs.
(Apply Breakable Thread
Locker)
Installation instructions
3
Publicité
