Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
GB
1. Mounting the detector .............................................................................. 8
2. Setting the detector ................................................................................. 8
3. Aligning the beam and walking testing the detector .............................. 10
4. General information ............................................................................... 11
5. Installation tips ....................................................................................... 13
6. Technical specifications ......................................................................... 13
1. Mounting the detector
1.
Lift off the custom insert (fig.
2.
Using a screwdriver, carefully prise open the detector (fig.
and 3).
3.
Remove the interior part (fig.
4.
Fix the base to the wall (fig.
5.
Wire the detector (figs.
6.
Select the desired jumper and DIP switch settings (Section 2).
Replace the interior part (fig. b).
7.
Align the detector, as shown (figs. c and i , and see Aligning the
8.
beam and walk testing the detector (section 3).
Remove the blinders and add the stickers, as required (figs. d and
9.
e)
10. Insert the insect-protection caps (fig. f, step 1).
11. Close the cover (fig. f, step 2).
12. Replace the custom insert (fig. f, step 3).
2. Setting the detector
Jumpers (figs.
J1 : PIR sensitivity
It changes the distance-to-alarm delay (the speed of the decision
algorithm); the higher the sensitivity, the faster the sensor will react (fig.
). There are three different PIR sensitivities.
Low sensitivity : Use where there is a risk of false alarms. Do
not use in long-range applications (>20 m).
Medium sensitivity: Most situations (ex-factory)
Installation Instructions
, step 1).
).
).
and
).
)
- 8 -
, steps 2
Publicité
Table des Matières
