HUDSON VALLEY LIGHTING L1516 Instructions D'installation

L1516 PORTABLE INSTALLATION INSTRUCTIONS
READ ALL INSTRUCTIONS COMPLETELY BEFORE STARTING INSTALLATION.
· THIS FIXTURE IS ONLY SUITABLE FOR DRY LOCATIONS.
THIS FIXTURE IS EQUIPPED WITH A POLARIZED PLUG (ONE BLADE IS WIDER THAN THE OTHER) .
·
· DO NOT PLUG INTO THE OUTLET UNTIL YOUR LAMP IS FULLY ASSEMBLED.
· The important safeguards and instructions outlined on this sheet cannot cover all possible conditions and situations that
may occur. It must be understood that common sense, caution and care factors that cannot be built into any product.
Caution and care must be supplied by the person(s) installing, operating and caring of this lighting fixture.
· This fixture is designed to be used on a stable, flat surface.
NOTICE
:
CALIFORNIA PROP 65:
CAUSE CANCER, BIRTH DEFECTS, AND/OR OTHER REPRODUCTIVE HARM. WASH HANDS AFTER USE.
FIXTURE PREPARATION
1. Remove the fixture, parts and parts bag(s) from the carton.
NOTICE:
· Before discarding the carton, double check to
make certain that all parts are found.
FIXTURE INSTALLATION
1. Insert the harp into the Saddle, and lower the harp caps until they cover
the two-pronged saddle.
2. Place the shade to the assembled harp, making sure the top extends through the
hole at the top of the shade.
3. Attach the finial and tighten to secure the shade.
4. Install the lamps. (
type-A lamp
NOTICE:
This fixture is rated for 75w type-A lamp.
WARNING
DO NOT EXCEED RECOMMENDED WATTAGE!
WARNING
SAFETY WARNINGS
NOTICE
THIS LIGHTING FIXTURE CONTAINS CHEMICALS KNOWN TO THE STATE OF CALIFORNIA TO
)