Charging The Unit - BST IPS10-250 Manuel D'utilisation

Wireless hand-held Microphone
1. Mesh & capsule
2. Power LED indicator
3. Display
4. Power switch
5. Plastic body
6. Battery cover
7. Frequency identification cap
1. Open the battery cover (6) and insert a battery with the correct polarity. Close the battery cover.
2. Turn on the microphone power switch (4). The power LED indicator (2) will flash once and then go off. If the
indicator (2) keeps light up in red, the battery power is low. Please change the battery.
3. When switching the microphone on, please proceed in 2 steps. Move the switch first to the center position and
wait for at least 0.2 seconds or it will produce noise. Then move to ON position.
Remote Control
17. MP3 power ON/OFF
18. Repeat: LCD displays "PONE" for single repetition or "PALL" for the
repetition of all files.
19. Mode: Select between USB and Bluetooth mode
20. CH-: Previous file
21. CH+: Next file
22. EQ: 00-NORMAL/01-POP/02-ROCK/03-JAZZ/04-CLASSIC/05-
COUNTRY
23. : Previous file
24. : Next file
25. Play/Pause
26. VOL-: volume down
27. VOL+: Volume up
28. Number keys: To select a 2 digit file, press 0 and then the 2 digits of
the file. Eg.: To select file 65, press 0+6+5
Quick Start
1. Set the POWER switch (2) to ON.
The battery charge is indicated by the LED indicator (4). Please charge the unit if the level is LOW.
The unit will switch off automatically when the battery runs low.
Insert the power cord into the DC input jack (1) to charge the unit.
2. Turn on the microphone power switch. The RF LED (6) or (7) on the control panel will light. This means that the
receiver is receiving the signal and is in normal working condition.
3. To use an external sound source, insert a signal cable into the AUX/MP3 input (14). Adjust the volume via the
LINE / MP3 volume control (10).
4. The unit has a TONE control (8), ECHO control (9) for a microphone effect, BASS (11) and TREBLE (12) controls.
5. Set the overall volume via the MASTER control (13).
6. Voice priority: Set the switch (3) to on. If you speak into the microphone, the music will be cut off and resume once
the microphone is not used anymore.

CHARGING THE UNIT

1. Prior to using this system for the first time, please insert the AC lead into the AC socket of the player and plug the
other end on a suitable wall outlet. Charging time is about 8-11 hours.
2. Please recharge once every 6 months if you don't use the system for a longer period of time.
NOTE: Please shut down the power switch after you have finished using the system.
Operation
1. Playing audio files: Select Bluetooth mode via the remote control or unplug the USB input so that the audio player
selects automatically Bluetooth mode.
2. Bluetooth connection: Turn on the Bluetooth function on your mobile device. Search and select "BST" for Bluetooth
connection.
©Copyright LOTRONIC 2018 IPS10-250 5