Inside This Package; Install Overview - Wilson Electronics PRO Serie Mode D'emploi

Inside this Package

To purchase Expansion Kits call Wilson Electronics Sales Department at:
Wide Band Directional
Signal
Antenna 75' RG11 Cable
Booster
(314475-1175)

Install Overview

Refer to Installation Diagram on page 3 & 4 . Contact Wilson Electronics Technical
Support Team with any questions at 866-839-9361
1 . Select a location on the roof or outside of the building to install the outside
antenna . Refer to pages 3 & 5 .
2 . Select a location to install the Signal Booster that is away from excessive heat,
direct sunlight or moisture, and has adequate ventilation . Airtight enclosures
are not recommended . Booster should be as close to the outside antenna as
possible in order to minimize losses from cable length to outside antenna .
3 . Connect the cable from the outside antenna to the signal booster's "outside
antenna" connector . Refer to page 6 for more information on running cable .
Lightning Surge Protection is recommended for all in-building installations .
Refer to pages 3 & 6 .
4 . Select a location for the inside antenna . Try to choose a position in the center
of the area needing improved signal . Keep in mind that proper inside antenna
to outside antenna isolation is necessary for the system to function properly .
This may require as much as 50 to 75 feet of horizontal separation from the
outside antenna . Vertical separation also helps increase isolation . Alternate
means of isolation are possible . If physical separation is not possible, please
contact Wilson Electronics Tech Support at 866-839-9361 for suggestions on
alternate methods to achieve isolation .
5 . Connect the cable from the inside antenna to the signal booster's "inside
antenna" connector . Refer to page 6 for more information on running cable .
Keep cable runs as short as possible to reduce signal loss in the system .
6 . Before powering up the signal booster, verify that both the outside antenna and
the inside antenna are connected correctly, and check that all connections are
tight . Refer to page 9 . Note: Be careful when plugging the connectors in so as
not to bend the center pins on the connectors.
7 . Power on the signal booster by plugging in the included power supply . If the
lights are not green, please refer to pages 9-11 .
Contact Wilson Electronics Customer Support Team with any questions at 866-839-9361
or email: tech@wilsonelectronics.com.
Note: Kits may contain different accessories
Wide Band Panel Antenna
50' RG11 Cable
(311155-1150)
For additional antenna options see pages 13 & 14.
888-503-5329
2' RG11 Cable
(951127) Power Supply
12V/3A (859900)
.
Mon.- Fri. Hours: 7 am to 6 pm MST.
AC/DC Lightning Surge
Protector
(859992)
2